Electromechanical two posts lifts with base
Base with small ramps for easy drive through.
Stabilising feet at the base of the posts.
Lifting height over 2 metres.
Tubular structure made of 5 robot welded sections, nothing sturdier in the world.
Automatic and permanent nut lubrication system to guarantee efficient lubrication during lifting and descent.
Main nut and safety nut made of bronze (no plastic) with high resistance to wear, for greater safety.
Steel high resistance rolled screws, to provide long life.
The carriage driven by 10 low friction slides on the post external part assure equilibrated and steady lifting also in case of asymmetric load and prevent the transmission of flexion to screws and nuts, granting long life.
Automatic arm locking during lifting and automatic unlocking when the arm reaches the floor – self-locking conical design.
Very low pad, adjustable height.
Specially manufactured motors fitted with overheating protection switch.
CE approved lift with low voltage controls.
The absence of feet around the posts allows free movements around the lift.
TOREK 32 PH / 3200 kg
Exclusive lift with self supporting base: installation is possible on floor with poor surface anchorage. Shaft transmission between posts through oil filled conic gear boxes requiring no maintenance.
Three stage short arms provide asymmetric lifting of off-road and large vehicles.
TOREK 35 PH / 3500 kg
Exclusive two motor lift with self supporting base.
Shaft transmission between posts through oil filled conic gear boxes requiring no maintenance.
Three-stage short arms and two-stage long arms provide asymmetric lifting of vans and off-road vehicles. Width between posts 2650 mm.
TOREK 35 PHLIK / 3500 kg
Model equipped with four long three-stage arms: ideal to lift long wheel base vans and easy lifting of cars.
Arms suitable for quick drop-in extensions and other lifting accessories.
Pictures reproduced are only indicative.
